The gas filter is leaking

　　Gas filter leakage, the reason is: the valve body, the lower cowl screw is not tightened;Damaged rubber film in valve body;Air inlet sealing ring aging damage.Treatment: screw down the top and lower cover;Replace the rubber film;The rubber seal ring of the connection between the pressure lowering valve and the cylinder performs the function of sealing the gas supply, it will be worn and aged after long-term use, and even in the alternative of the cylinder will fall off and reason a lot of walking gas, causing serious accidents.Therefore, each time to substitute the cylinder, the set up of stress relief valve, should pay interest to test whether or not the rubber seal ring is intact, there is no aging, wear phenomenon, specially in the installation, ought to take a look at whether or not the seal ring is missing.If it has been growing old or wear, must be replaced in time, however reducing is not viable with movie slicing into substitution, should use the sealing ring.TXXBoiler Burner

　　The respiratory gap is blocked and the strain cannot be adjusted.The authentic problem caused by the failure to pay attention to day by day preservation and cleaning caused the debris to stain the stress reducing valve and make the small round gap with a diameter of about 1mm in its upper shell blocked.This small spherical gap is the respiratory hole, the respiratory hole and the strain relief valve in the rubber movie cavity connected, when the diaphragm movement, air continuously from the respiratory gap in and out, to attain pressure regulation.Therefore, if the breather gap is blocked, the air above the diaphragm cannot usually glide in and out, which motives the failure of LPG pressure regulation, ensuing in the direct air furnish of high-pressure LPG, which makes the flame of the fuel become large or extinguish the flame and run out of gas, main to hearth accidents.TXXBoiler Burner

　　Treatment of fuel filter leakage: often check and clean, hold the respiration hole open.When a leak of liquefied petroleum gasoline (LPG) from the breather gap is found, indicating that the rubber movie is damaged, the corner valve be closed, the pressure alleviation valve removed, the diaphragm changed or its new pressure relief valve replaced.TXXBoiler Burner

　　Flow or pressure is not normal, flow decreases, the major cause is used too long, cause rubber seal ring enlargement deformation.If deformation, have to replace the apron.Insufficient inlet pressure: usually, this is brought about with the aid of blockage of the filter.TXXBoiler Burner